• <nav id="008o8"></nav>
    <nav id="008o8"></nav>
    • Address

      Shuanghu Production Base, Daxin Town,
      Jimo District, Qingdao City, Shandong Province, China

    • Tel

      13608972095
      0532-82530116

    Cleaning steps and precautions for conveyor belt of needle detector
    Addtime:2019-1-16 10:18:27   Author:雙虎   Clicks:745


    Because the needle detector is a kind of highly sensitive detection instrument, it has relatively strict requirements for the environment and maintenance of the machine. Usually after a period of time, the needle detector will have some common "breakdowns", so in normal use should be regularly clean the conveyor belt and other vulnerable parts. The cleaning methods and precautions are as follows:


    1. Cleaning utensils: Find a clean towel and twist it dry after wetting until it can't twist out the water.


    2. Conveyor Belt Surface Cleaning: Note that before cleaning, the sensitivity of the needle detector should be adjusted to the lowest level. If the needle detector has B/C mode, please adjust the needle detector to C mode, so as to avoid the high sensitivity affecting the next cleaning work. Then straighten the towel and press it properly on the surface of the conveyor belt, start the machine, make the machine run more than five circles (for the purpose of cleaning the contaminants on the surface of the conveyor belt, this method can be applied flexibly by itself). Then wash and dry the towel, and repeat this step again to wipe the conveyor belt until there is no obvious contaminants on the surface of the conveyor belt;


    3. Clean the back of conveyor belt: Then wash and twist the towel, pass the towel through the bottom of conveyor belt from the lower part of the machine, straighten the towel, pull the towel to the front of conveyor platform, hold the towel tightly at both ends, and start the machine to run for several weeks. Because the bottom of the conveyor belt is the dirtiest place, it needs to be wiped many times. After several weeks of each operation, the towel should be pulled out and washed, and repeat the above steps again.


    3. How to judge the cleaning effect: After the two cleaning steps mentioned above, the conveyor belt of the needle detector adjusts the sensitivity to level 8 or the highest sensitivity. Turn on the machine and let the machine run. If the machine runs smoothly and the metal position display lamp of the probe is not on, then put the clothes without any metal impurities into it. The clothes can pass through the needle detector channel smoothly, that is, the conveyor belt is cleaned successfully.


    If after the above steps of cleaning, it is still found that the probe lamp flickers continuously after power-on, and the clothes can not pass smoothly, because the above cleaning steps are repeated again. At the same time, when testing after cleaning, it is necessary to avoid the surrounding interference environmental factors, such as: personnel walking, large machine distance too close and other factors need to be taken into account!

    大地彩票app官网